Fibaro Z-Wave in-wall Relay Switch
Discontinued and replaced by newer model Fibaro 2.5kW single relay. Fibaro On / Off Relay Switch is designed to be installed behind standard wall switch or anywhere else where it is necessary to operate an electric device of up to 3kW. It can control connected device either through z-wave or through the wall switch connected directly to it.
Fibaro Z-Wave In-Wall Relay Switch
Discontinued and replaced by newer model Fibaro 2.5kW single relay.
Fibaro Z-Wave activated relay switch which can also be triggered from existing mains switches so that manual control of the load is still possible using the existing switch plate. Easily transform your existing light switch to an automated one or use it to control other electric appliances like pumps, motor, sprinklers etc . This is a 3 wire device requiring a live and neutral connection.
♦ Control On/Off control of devices
♦ Ease of use and installation by qualified electrican only
♦ Optimised antenna range for indoor use, up to 20m
♦ Max 3000W circuit 240V
♦ Z-wave and manual operations
♦ Small form factor that can be easily hidden away
Integrates with all certified Z-Wave controllers in Australian ffrequency (921.42MHz)
Technical Specifications
|
Description
|
|
|
RF Protocol
|
Z-Wave (Multilevel Command Class)
|
|
Z-wave device type
|
Z-wave binary switch, routing slave
|
|
Operating Voltage
|
AC 230V / 50Hz
|
|
Max Loading
|
3000W circuit
|
|
RF Frequency
|
921.42Mhz - AU/NZ approved RF for Z-wave
|
|
Operation Range
|
Up to 30m when no obstacles
|
|
Application
|
Indoor use only
|
|
Operation temperature
|
10 ~ 40 °C
|
|
Overheating protection
|
105 degrees
|
|
Housing
|
ABS
|
|
Dimensions
|
(L x W x H) 42mm x 36mm x 15mm
|
| Repeats z-wave signals | Yes |
|---|---|
| DIY | No |
| Electrican Required | Yes |
| Neutral wire requirement | No |
