Aeotec Z-Wave Dimmer Bypass

Special Price A$18.00 Regular Price A$26.00
In stock

The Aeotec Dimmer Bypass enables the Nano Dimmer module to control loads that are below the minimum requirement. The bypass eliminate the flickering and instability associated with insufficient load on the circuit or off-peak surge.

Aeotec Z-Wave Nano Dimmer Bypass

The Aeotec Nano z-wave dimmer require a minimun load otherwise it may not work properly or flicker. 
Bypass works with Nano Dimmer to remove the signals from your power line to resolve this issue.

There are a lot of different types of low-power light bulbs that your home may have; Bypass has been designed to work with most of them including static and dimmable LEDs and CFLs. This bypass only works for Aeotec Nano Dimmer so not compatible with any other modules. 

♦ Supports low-power lamps such as LEDs

♦ Fits into wall socket alongside the Dimmer module or inside the light fitting

♦ Easy installation by electrican

To determine if you need a Bypass load, determine if your load meets the minimum power requirements. ie if the total load on your lighting circuit is lower than the min load in the table you need a bypass.

Installation Type Minimum load power requirement
3-wire Installation with Neutral  10W
2-wire Installation without Neutral  20W

More Information
Repeats z-wave signalsYes
Electrican RequiredYes
Neutral wire requirementNo
You may also like!