Fibaro Z-Wave in-wall Universal Dimmer
Discontinued and replaced by the Fibaro dimmer 2. The most compatible z-wave dimmer for LED lighting, the Fibaro module is a highly configurable z-wave dimmer with features such as soft start and memory of the last lighting level settings.
This is a 2 or 3 wire device so does not require a neutral connection.
Fibaro Z-Wave In-Wall Dimmer
Discontinued and replaced by the Fibaro dimmer 2
The fibaro dimmer is one of the best z-wave dimmer available for LED lighting and can be used with momentary, toggle and 3-position switches. z-wave and local control of the light is possible and the Z-Wave controller will be able to override the manual switch. Designed to be hidden away behind existing wall switch and works with or without neutral lead. Its compact size means that it can be fitted inside wall boxes, directly behind a wall switch or can located anywhere between the switch and load. Fibaro is a leading edge dimmer only and compatible with a large range of dimmable LEDs.
Requires minimum load of 25W on the lighting circuit otherwise you will need to use a dimmer bypass
Easily transform your existing light switch to an automated one.
♦ Dimming and control On/Off control of home lighting
♦ 2 or 3 wire system and installation by qualified electrican only
♦ Optimised antenna range for indoor use, up to 20m
♦ Min 25W to 500W circuit 240V
♦ Z-Wave RF frequency 921.42MHz (Aus/NZ)
♦ Z-wave and manual operations
♦ Integrates with all certified AUS/NZ Z-Wave controllers
♦ Small form factor that can be easily hidden away (42 x 37 x 17mm)
| Repeats z-wave signals | Yes |
|---|---|
| DIY | No |
| Electrican Required | Yes |
| Neutral wire requirement | No |
